Gemalto Cinterion EHS6 - 20.2 AT^SGIO Get IO State of a Specified Pin

Cinterion
®
EHS6 AT Command Set 
20.2 AT^SGIO
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 476 of 513
20.2 AT^SGIO Get IO State of a Specified Pin
Syntax

Parameter Description
This is an already configured <pin_id> (see AT^SCPIN).
State read on this <io_id>.
0Low for <pin_id>
1 High for <pin_id>
Test Command
AT^SGIO=?
Response(s)
^SGIO:(list of supported <io_id>s)
OK
Write Command
AT^SGIO=<io_id>
Response(s)
^SGIO: <value>
OK
ERROR
+CME ERROR: <err>
PIN  Last
- + -
<io_id>
(num)
<value>
(num)