Cinterion
®
EHS6 AT Command Set
7.18 AT+CR
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 156 of 513
7.18 AT+CR Service reporting control
AT+CR configures the TA whether or not to transmit an intermediate result code +CR: <serv> to the TE when a
call is being set up.
Setting the value of <mode> to 1 may lead to connection failure, if the TE waits for default result code/URC.
Syntax
Intermediate Result Code
If enabled, an intermediate result code is transmitted during connect negotiation when the TA has determined
the speed and quality of service to be used, before any error control or data compression reports are transmitted,
and before any final result code (e.g. CONNECT) appears.
+CR: <serv>
Parameter Description
0
(&F)(P)
Disable
1 Enable
“REL ASYNC“ Asynchronous non-transparent
“GPRS [<L2P>]“ GPRS
The optional [<L2P>] proposes a layer 2 protocol to use between ME and TE.
It is defined by AT+CGDATA.
“SYNC“ Synchronous transparent
“REL SYNC“ Synchronous non-transparent
“ASYNC“ Asynchronous transparent
Test Command
AT+CR=?
Response(s)
+CR: (list of supported<mode>s)
OK
ERROR
Read Command
AT+CR?
Response(s)
+CR: <mode>
OK
ERROR
Write Command
AT+CR=<mode>
Response(s)
OK
ERROR
PIN Last Reference(s)
+ + - 3GPP TS 27.007 [45]
<mode>
(num)(&V)(&W)
<serv>
(str)
To Next Page
Loading...
