Gemalto Cinterion EHS6 User Manual

Cinterion
®
EHS6 AT Command Set 
21.5 Factory Default Settings Restorable with AT&F
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 502 of 513
21.5 Factory Default Settings Restorable with AT&F
Table 21.8: Factory Default Settings Restorable with AT&F
AT Command Factory Defaults

Configuration Commands
ATQ <n>=0
ATV <value>=1
ATX <value>=4
AT+CMEE <errMode>=0
AT+CSCS <chset>="GSM"

Serial Interface Control Commands
AT\Q <n>=3
AT&C <value>=1
AT&D <value>=2
AT&S <value>=0
ATE <value>=1
AT+ICF <format>=3

Call related Commands
ATS0 <n>=000
AT+CBST <speed>=7, <name>=0, <ce>=1
AT+CRLP <iws>=61, <mws>=61, <T1>=78, <N2>=6
AT+CR <mode>=0
AT+CRC <mode>=0
ATS7 <n>=060
ATS8 <n>=000
ATS10 <n>=002

Network Service Commands
AT+COPS <format>=0
AT+CREG <Mode>=0

Supplementary Service Commands
AT+CLIP <n>=0
AT+CNAP <n>=0

Short Message Service (SMS) Commands
AT+CMGF <mode>=0
AT+CNMI <mode>=1, <mt>=0, <bm>=0, <ds>=0, <bfr>=0
AT+CSDH <show>=0
AT+CSMS <service>=0

Gemalto Cinterion EHS6 Specifications

General

Brand	Gemalto
Model	Cinterion EHS6
Category	Control Unit
Language	English