Cinterion
®
EHS6 AT Command Set
12.12 AT+CNMI
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 339 of 513
URC 4
<bm>=2 (PDU mode enabled):
+CBM: <length><CR><LF><pdu>
Indicates that new cell broadcast message has been received
URC 5
<bm>=2 (text mode enabled):
+CBM: <sn>, <mid>, <dcs>, <page>, <pages><CR><LF><data>
Indicates that new cell broadcast message has been received
URC 6
<bm>=1 or 3:
+CBMI: <mem3>, <index>
Indicates memory location of newly received cell broadcast message
URC 7
<ds>=1 (PDU mode enabled):
+CDS: <length><CR><LF><pdu>
Indicates that new SMS status report has been received
URC 8
<ds>=1 (text mode enabled):
+CDS: <fo>, <mr>[, <ra>][, <tora>], <scts>, <dt>, <st>
Indicates that new SMS status report has been received
URC 9
<ds>=2:
+CDSI: <mem3>, <index>
Indicates that new SMS status report has been received
Parameter Description
[0] SMS related URCs are always buffered in the ME. If the buffer is full, the oldest
indications are discarded and replaced with newly received indications.
1
(&F)(P)
SMS related URCs are forwarded directly to the TE. However, if this is not pos-
sible because ME-TE link is reserved, e.g. during a data call, these URCs are
discarded.
2 SMS related URCs are forwarded directly to the TE. However, if this is not pos-
sible because ME-TE link is reserved these URCs are buffered and flushed to
the TE afterwards.
Rules for storing received short messages depend on the relevant data coding method (refer to
3GPP TS 23.038 [35]), preferred memory storage (AT+CPMS) setting and this value.
[0]
(&F)(P)
No SMS-DELIVER indications are routed to the TE.
1 Class 0 SMS-DELIVERs are routed directly to the TE via URC. For all other
messages the following applies: If SMS-DELIVER is stored in UE, indication of
the memory location is routed to the TE via URC.
<mode>
(num)(&V)(&W)
<mt>
(num)(&V)(&W)
To Next Page
Loading...
Need help?
General
