Cinterion
®
EHS6 AT Command Set
11. Packet Domain Related Commands
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 283 of 513
11. Packet Domain Related Commands
The AT commands described in this chapter allow the Customer Application to control packet switched services
in networks.
11.1 AT+CGACT PDP context activate or deactivate
The AT+CGACT write command is used to activate or deactivate the specified PDP context(s). After the command
has completed, the MT remains in V.250 command state. If any PDP context is already in the requested state,
the state for that context remains unchanged. If the MT is not PS attached when the activation form of the com-
mand is executed, the MT first performs a PS attach and then attempts to activate the specified contexts.
The AT+CGACT read command returns the current activation states for all the defined PDP contexts.
The AT+CGACT test command is used for requesting information on the supported PDP context activation states.
Syntax
Parameter Description
Indicates the state of PDP context activation.
0 Detached
[1] Attached
Test Command
AT+CGACT=?
Response(s)
+CGACT: (list of supported <state>s)
OK
Read Command
AT+CGACT?
Response(s)
+CGACT: [<cid>, <state>]
[+CGACT: <cid>, <state>]
...
OK
Write Command
AT+CGACT=<state>[, <cid>[, <cid>]]
Response(s)
+CGACT: [<cid>, <state>]
[+CGACT: <cid>, <state>]
...
OK
ERROR
+CME ERROR: <err>
PIN Last Reference(s)
+ + - 3GPP TS 27.007 [45]
<state>
(num)
To Next Page
Loading...
Need help?
General
