Gemalto Cinterion EHS6 - 21.4 AT Command Settings storable with AT&W

Cinterion
®
EHS6 AT Command Set 
21.4 AT Command Settings storable with AT&W
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 500 of 513
21.4 AT Command Settings storable with AT&W
Table 21.7: Settings Stored to User Profile
AT Command Stored Parameters

Configuration Commands
ATQ <n>
ATV <value>
ATX <value>
AT+CMEE <errMode>
AT+CSCS <chset>

Status Control Commands
AT^SIND <dtmfSrc>, <dtmfSilenceTime>, <dtmf-
BufferTimeout>, <dtmfMinToneTime>

Serial Interface Control Commands
AT\Q <n>
AT&C <value>
AT&D <value>
AT&S <value>
ATE <value>
AT+ICF <format>, <parity>

Call related Commands
ATS0 <n>
AT+CBST <speed>, <name>, <ce>
AT+CRLP <iws>, <mws>, <T1>, <N2>
AT+CR <mode>
AT+CRC <mode>
ATS6 <n>
ATS7 <n>
ATS8 <n>
ATS10 <n>

Network Service Commands
AT+COPS <format>
AT+CREG <Mode>

Supplementary Service Commands
AT+CLIP <n>
AT+CNAP <n>

Short Message Service (SMS) Commands
AT+CMGF <mode>