Gemalto Cinterion EHS6 User Manual

Cinterion
®
EHS6 AT Command Set 
3.2 AT^SIND
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 100 of 513
Start frequency of the scan. Refer to <indDescr>.
End frequency of the scan. Refer to <indDescr>.
Grade derived from the <lstaMean> value of the power scan results. Refer to <indDescr>.
DTMF character string of the "dtmf" URC.
Source of the DTMF signal. Refer to <indDescr>, "dtmf".
0 DTMF source is local
1
(D)
DTMF source is network
0
(D)
...40...65535 Minimum silence time in milliseconds after which the ME is ready to detect the
next valid DTMF tone. Depends on <dtmfSrc> and DTMF scenario. Refer to
<indDescr>, "dtmf".
0
(D)
...65535 Timeout in milliseconds for emptying the DTMF buffer. If the timeout is disabled
with <dtmfBufferTimeout>=0, the "dtmf" URC will be sent for each single
DTMF character. Refer to <indDescr>, "dtmf".
0
(D)
...45...100 Minimum duration of a DTMF character the can be detected in milliseconds
and in steps of 5 milliseconds. If set to 0 the parameter has no effect on the
detection. Refer to <indDescr>, "dtmf".
<lstaFrStart>
(num)
<lstaFrEnd>
(num)
<lstaGrade>
(num)
<dtmfChar>
(str)
<dtmfSrc>
(num)(&W)
<dtmfSilenceTime>
(num)(&W)
<dtmfBufferTimeout>
(num)(&W)
<dtmfMinToneTime>
(num)(&W)

Gemalto Cinterion EHS6 Specifications

General

Brand	Gemalto
Model	Cinterion EHS6
Category	Control Unit
Language	English