Cinterion
®
EHS6 AT Command Set
9.10 AT+COLP
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 214 of 513
9.10 AT+COLP Connected Line Identification Presentation
AT+COLP refers to the supplementary service COLP (Connected Line Identification Presentation) that enables a
calling subscriber to get the connected line identity (COL) of the called party after setting up a mobile originated
call. The command enables or disables the presentation of the COL at the TE. It has no effect on the execution
of the supplementary service COLR in the network.
Syntax
Unsolicited Result Code
Call response format:
+COLP: <number>, <type>
Parameter Description
0 Disable - suppress unsolicited result codes
1 Enable - display unsolicited result codes
0 COLP not provisioned (no presentation)
1 COLP provisioned
2 Unknown
String type phone number of connected address in format specified by <type>
Test Command
AT+COLP=?
Response(s)
+COLP:(list of supported <n>s)
OK
Read Command
AT+COLP?
Response(s)
+COLP: <n>, <m>
OK
ERROR
+CME ERROR: <err>
Write Command
AT+COLP=[<n>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN Last Reference(s)
+ - - 3GPP TS 27.007 [45]
<n>
(num)
<m>
(num)
<number>
(str)
To Next Page
Loading...
Need help?
General
