Gemalto Cinterion EHS6 - 8.14 AT^SNMON Network Monitoring

Cinterion
®
EHS6 AT Command Set 
8.14 AT^SNMON
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 194 of 513
8.14 AT^SNMON Network Monitoring
The AT^SNMON command can be used to monitor various network information. 
Syntax
Test Command
AT^SNMON=?
Response(s)
^SNMON: "INS", (list of supported <action>s)
^SNMON: "NBC", (list of supported <action>s)
^SNMON: "NBC/CFG/3GPP", (list of supported <action>s), (list of supported <ratNBC>s), (list of
supported <cellNo>s)
OK
ERROR
+CME ERROR: <err>
Write Command
Start network scan. <action> shall be 2.
AT^SNMON="INS", <action>
Response(s)
If <ratINS>= 0:
^SNMON: "INS", <reserved>, <rb>, <ratINS>, <cell_Id>, <lac>, <plmn>, <arfcn>, <rssi>,
<dbm>, <gprs_avail>
[^SNMON: ...]
If <ratINS>= 2:
^SNMON: "INS", <reserved>, <rb>, <ratINS>, <cell_Id>, <lac>, <plmn>, <uarfcn>, <rscp>,
<dbm>, <psc>
[^SNMON: ...]
If no cell can be found for a specific band all values behind <rb> are omitted:
^SNMON: "INS", <reserved>, <rb>
OK
ERROR
+CME ERROR: <err>
Write Command
Start neighbor cell scan. <action> shall be 2.
AT^SNMON="NBC", <action>
Response(s)
[^SNMON: "NBC", <reserved>, 2G, <arfcn>, <rssi>, <ncc>, <bcc>, <mcc>, <mnc>, <lac>,
<cell_Id>]
[^SNMON: "NBC", <reserved>, 3G, <uarfcn>, <psc>, <ec/n0>, <rscp>, <mcc>, <mnc>, <lac>,
<cell_Id>]
If neighbor cell ID is not available:
[^SNMON: "NBC", <reserved>, 2G, <arfcn>, <rssi>, <ncc>, <bcc>, , , , ]
[^SNMON: "NBC", <reserved>, 3G, <uarfcn>, <psc>, <ec/n0>, <rscp>, , , , ]
If neighbor cell scan output is disabled (<cellNo>=0):
OK
ERROR
+CME ERROR: <err>