Cinterion
®
EHS6 AT Command Set
8.14 AT^SNMON
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 197 of 513
Absolute Radio Frequency Channel Number of the BCCH carrier.
Received signal level of the BCCH carrier. The indicated value is composed of the measured value in dBm plus
an offset. This is in accordance with a formula specified in 3GPP TS 45.008 [50]
UTRAN Absolute Radio Frequency Channel Number of the BCCH carrier
PSC (Primary Scrambling Code)
RSCP (Received Signal Code Power in dBm)
Location Area Code
Two byte location area code in hexadecimal format (e.g. "00C1" equals 193 in decimal) of the cell that was
scanned.
Cell ID (16 bit for GSM), (28 bit for UMTS)
Notes
•The AT^SNMON="INS" command can be used even if no SIM is present or no SIM-PIN was entered.
•The AT^SNMON="INS" command depends on the registration state. Network scan is only possible if the mod-
ule is not registered. To perform a scan it is needed to deregister manually from the network.
•The AT^SNMON="INS" command may be aborted internally by any other network related activity that inter-
feres with the network scan.
• The time required for a network scan depends not only on the number of radio bands to be scanned, but also
on ripple and existing ghost peaks on the scanned radio bands.
<arfcn>
(num)
<rssi>
(num)
<uarfcn>
(num)
<psc>
(num)
<rscp>
(num)
<lac>
(str)
<cell_Id>
(str)
To Next Page
Loading...
