Gemalto Cinterion EHS6 - 11.13 AT+CGQREQ Quality of Service Profile (Requested)

Cinterion
®
EHS6 AT Command Set 
11.13 AT+CGQREQ
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 309 of 513
11.13 AT+CGQREQ Quality of Service Profile (Requested)
The AT+CGQREQ command allows the TE to specify a Quality of Service Profile that is used when the MT sends
an Activate PDP Context Request message to the network.
The AT+CGQREQ write command specifies a profile for the context identified by the (local) context identification
parameter, <cid>. 
A special form of the write command, +CGQREQ=<cid> causes the requested profile for context number
<cid> to become undefined.


The AT+CGQREQ test command returns values supported as a compound value. If the MT supports several PDP
types, the parameter value ranges for each PDP type are returned on a separate line. 

The AT+CGQREQ read command returns the current settings for each defined context. If no requested profile was
explicitly specified for a context, simply OK will be returned, but default values will be used for that context. 
Syntax

Parameter Description
Parameter specifies a particular PDP context definition (see AT+CGDCONT parameter <cid>). The parameter
is used in other PDP context-related commands.
Precedence class
[0] network subscribed value
1 High Priority
Service commitments shall be maintained ahead of precedence classes 2 and
3
Test Command
AT+CGQREQ=?
Response(s)
+CGQREQ: <PDP_type>, (list of supported <precedence>s), (list of supported <delay>s), (list of
supported <reliability>s), (list of supported <peak>s), (list of supported <mean>s)
OK
Read Command
AT+CGQREQ?
Response(s)
[+CGQREQ: <cid>, <precedence>, <delay>, <reliability>, <peak>, <mean>]
[+CGQREQ: ...]
Write Command
AT+CGQREQ=[<cid>[, <precedence>[, <delay>[, <reliability>[, <peak>[, <mean>]]]]]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN  Last Reference(s)
+ + - 3GPP TS 27.007 [45]
<cid>
(num)(NV)
<precedence>
(num)(NV)