Gemalto Cinterion EHS6 - 12.16 AT+CSDH Show SMS text mode parameters

Cinterion
®
EHS6 AT Command Set 
12.16 AT+CSDH
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 345 of 513
12.16 AT+CSDH Show SMS text mode parameters
The write command sets whether or not detailed header information is shown in text mode result codes. 
Syntax

Parameter Description
[0]
(&F)(D)
Do not show header values defined in commands AT+CSCA and AT+CSMP
(<sca>, <tosca>,<fo>,<vp>, <pid> and <dcs>) nor <length>, <toda> or
<tooa> in "+CMT", AT+CMGL, AT+CMGR result codes for SMS-DELIVERs and
SMS-SUBMITs in text mode; for SMS-COMMANDs in +CMGR result code, do
not show <pid>,<mn>,<da>, <toda>, <length> or <cdata>
1 Show the values in result codes
Test Command
AT+CSDH=?
Response(s)
+CSDH: (list of supported <show>s)
OK
Read Command
AT+CSDH?
Response(s)
+CSDH:<show>
OK
Write Command
AT+CSDH=<show>
Response(s)
OK
PIN  Last Reference(s)
- + - 3GPP TS 27.005 [44]
<show>
(num)(&W)