Cinterion
®
EHS6 AT Command Set
17.4 AT^SJNET
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 418 of 513
17.4 AT^SJNET Set Dialup Network Access Parameters
The AT^SJNET write command allows to create a profile which contains all parameters needed for automated
network access through a dialup connection.
Syntax
Parameter Description
““
(P)
No bearer specified
“gprs“ Dialup access via GPRS
““
(P)
If <bearer service> is "gprs", then parameter specifies the GPRS access
point name.
““
(P)
Specifies the login name for access to the dialup network.
Parameter is global for all interfaces, volatile and will not be reset by AT&F.
““
(P)
Specifies the password for access to the dialup network.
Parameter is global for all interfaces, volatile and will not be reset by AT&F.
Test Command
AT^SJNET=?
Response(s)
^SJNET:("gprs"), ("string length range of <entry point>"), ("string length range of <login>"), ("string
length range of <password>"), ("string length range of <dns>"), (0-21600)
OK
Read Command
AT^SJNET?
Response(s)
^SJNET: <bearer service>, <entry point>, <login>, <password>, <dns>, <timeout>
OK
ERROR
+CME ERROR: <err>
Write Command
AT^SJNET=<bearer service>, <entry point>, <login>, <password>[, <dns>][, <timeout>]
Response(s)
^SJNET: <bearer service>, <entry point>, <login>, <password>, <dns>, <timeout>
OK
ERROR
+CME ERROR: <err>
PIN Last
+ + -
<bearer service>
(str)(+CSCS)
<entry point>
(str)(+CSCS)
<login>
(str)(+CSCS)
<password>
(str)(+CSCS)
To Next Page
Loading...
Need help?
General
