Cinterion
®
EHS6 AT Command Set
19.3 AT^SBV
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 454 of 513
19.3 AT^SBV Battery/Supply Voltage
AT^SBV allows to monitor the supply (or battery) voltage of the module. The voltage is periodically measured.
The displayed value is averaged.
The measurement is related to the reference points of BATT+ and GND. For details on the reference points
please refer to the Hardware Interface Description [2]. If the measured average voltage drops below or rises
above the given voltage thresholds the ME will report alert messages by sending the "^SBC" URCs listed in Sec-
tion 1.8.1, Common URCs.
Syntax
Parameter Description
Supply (or battery) voltage in mV
Test Command
AT^SBV=?
Response(s)
OK
ERROR
+CME ERROR: <err>
Exec Command
AT^SBV
Response(s)
^SBV: <Voltage>
OK
ERROR
+CME ERROR: <err>
PIN Last
- + -
<Voltage>
(num)
To Next Page
Loading...
Need help?
General
