Cinterion
®
EHS6 AT Command Set
9.9 AT+CLIR
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 213 of 513
9.9 AT+CLIR Calling Line Identification Restriction
The AT+CLIR command refers to the supplementary service CLIR (Calling Line Identification Restriction).
Syntax
Parameter Description
Parameter shows the settings for outgoing calls:
[0]
(P)
Presentation indicator is used according to the subscription of the CLIR service
1 CLIR invocation
2 CLIR suppression
Parameter shows the subscriber CLIR service status in the network:
0 CLIR not provisioned
1 CLIR provisioned in permanent mode
2 Unknown (e.g. no network, etc.)
3 CLIR temporary mode presentation restricted
4 CLIR temporary mode presentation allowed
Note
• The settings made with AT+CLIR=1 or AT+CLIR=2 are used for all outgoing calls until the ME is switched off
or AT+CLIR=0 is used.
Test Command
AT+CLIR=?
Response(s)
+CLIR: (list of supported <n>s)
OK
Read Command
AT+CLIR?
Response(s)
+CLIR<n>, <m>
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CLIR=<n>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN Last Reference(s)
+ - - 3GPP TS 27.007 [45]
<n>
(num)
<m>
(num)
To Next Page
Loading...
Need help?
General
