Cinterion
®
EHS6 AT Command Set
11.1 AT+CGACT
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 284 of 513
Parameter specifies a particular PDP context definition (see AT+CGDCONT parameter <cid>). The parameter
is used in other PDP context-related commands.
Notes
• A maximum of 3 contexts can be activated at the same time, no matter on which interface. Note that, depend-
ing on the provider, the number of activated contexts may be further restricted.
Remember that contexts may be activated implicitly by using other commands, e.g. AT+CGDATA or ATD*99#.
• If activation or deactivation of a context fails, then AT+CEER may provide further informations about the rea-
son.
<cid>
(num)
To Next Page
Loading...
