Gemalto Cinterion EHS6 User Manual

Cinterion
®
EHS6 AT Command Set 
9.5 AT+CCFC
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 204 of 513
3Register <number> and activate Call forwarding (register service)
4 Erase <number> and deactivate call forwarding (erase service)
String type phone number of forwarding address in format specified by <type>. If you select <mode>= 3, the
phone <number> will be registered in the network. This allows you to disable / enable CF to the same destination
without the need to enter the phone number once again. Depending on the services offered by the provider the
registration may be mandatory before CF can be used. The number remains registered in the network until you
register another number or erase it using <mode> = 4.
Type of address octet
145 Dialing string <number> includes international access code character '+'
129 Otherwise
Integer or sum of integers each representing a class of information, i.e. a bearer service, telecommunication ser-
vice or bearer service group as defined in 3GPP TS 22.004 [25]
1Voice
2Data
<class> 2 (data) comprises all those <class> values between 16 and 128, that
are supported both by the network and the MS. This means, a setting made for
<class> 2 applies to all remaining data classes (if supported). In addition, you
can assign a different setting to a specific class. For example, you can activate
Call Forwarding for all data classes, but deactivate it for a specific data class.
4 Fax (only for compatibility reasons, not supported by EHS6)
8SMS
16 Data circuit sync
32 Data circuit async
64 Dedicated packet access
128 Dedicated PAD access
1...[7]...255 combination of some of the above classes. For example, the default setting 7
represents the sum of the integers 1, 2 and 4 for voice, data and fax (fax only
for compatibilty reasons). The value 255 covers all classes. If the <class>
parameter is omitted, the default value 7 is used.
Only for compatibility reasons, not supported by EHS6
Only for compatibility reasons, not supported by EHS6
5...[20]...30 Time to wait before call is forwarded, rounded to a multiple of 5 sec. (only for
<reason>=no reply)
0 Call Forwarding not active
1 Call Forwarding active
<number>
(str)
<type>
(num)
<class>
(num)
<subaddress>
(str)
<satype>
(num)
<time>
(num)
<status>
(num)

Gemalto Cinterion EHS6 Specifications

General

Brand	Gemalto
Model	Cinterion EHS6
Category	Control Unit
Language	English