Cinterion
®
EHS6 AT Command Set
10.1 AT^SICS
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 229 of 513
Parameter Description
0...5 Internet connection profile identifier.
The <conProfileId> identifies all parameters of a connection profile, and,
when a service profile is created with AT^SISS the <conProfileId> needs
to be set as "conId" value of the AT^SISS parameter <srvParmTag>.
Internet connection parameter.
“conType“ Type of Internet connection.
For supported values of <conParmValue> refer to <conParmValue-con-
Type>.
“user“ User name string: maximum 31 characters (where "" is default).
“passwd“ Password string: maximum 31 characters (where ***** is default).
“apn“ Access point name string value: maximum 99 characters (where "" is default).
“inactTO“ Inactivity timeout value in seconds: 0 ... 2
16
-1, default = 20
Number of seconds the bearer remains open although the service no longer
needs the bearer connection.
Setting the value to 0 does not deactivate the timer. If the value is set to 0, the
bearer is closed immediately after the service no longer needs the connection.
Short timeout may result in problems when using the <eodFlag> (set in the
last AT^SISW command to terminate an upload data stream). It is possible that
the bearer will get closed before the flag will be transmitted. As result the server
will not receive the flag. Considering this avoid setting the timeout value below
3 seconds when using the <eodFlag>.
“dns1“ Primary DNS server address (IPv4 address in dotted-four-byte format).
This value determines whether to use the DNS server addresses dynamically
assigned by the network or a specific DNS server address given by the user.
"dns1" = "0.0.0.0" (default) means that the CSD or GPRS connection profile
uses dynamic DNS assignment. Any other address means that the Primary
DNS is manually set.
The default value applies automatically if no other address is set. Note that the
AT^SICS read command only returns a manually configured IP address, while
the value "0.0.0.0" is not indicated at all, no matter whether assumed by default
or explicitly specified.
See also note below.
Parameter value; type and supported content depend on related <conParmTag>.
Supported connection type values in <conParmValue> for <conParmTag> value "conType".
“GPRS0“ Packet switched connection type IPv4.
Settings of Packet Domain related commands are not used, e.g. AT+CGDCONT.
However, for each configured connection profile there must be a free PDP con-
text in AT+CGDCONT. After entering AT^SISO EHS6 automatically tries to
attach to a Packet Domain. Yet, the only exception is AT+CGATT which can be
used any time to detach from the Packet Domain and thus disconnect the
bearer opened with AT^SISO.
“none“ Clears the connection profile.
<conProfileId>
(num)
<conParmTag>
(str)
<conParmValue>
(str)(+CSCS)
<conParmValue-conType>
(str)
To Next Page
Loading...
Need help?
General
