Gemalto Cinterion EHS6 - Page 9

Cinterion
®
EHS6 AT Command Set
Contents
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 9 of 513
20. General Purpose I/O (GPIO) Pin related Commands........................................................................ 473
20.1 AT^SCPIN Pin Configuration .................................................................................................... 473
20.1.1 GPIO Configuration Table ........................................................................................... 474
20.2 AT^SGIO Get IO State of a Specified Pin ................................................................................. 476
20.3 AT^SSIO Set IO State of a Specified Pin.................................................................................. 477
20.4 AT^SCPOL Polling Configuration.............................................................................................. 478
20.5 AT^SSCNT Start and Stop Pulse Counter ................................................................................ 479
20.5.1 Using the Pulse Counter in Start-Stop Counter Mode ................................................. 480
20.6 AT^SCCNT Configure Pulse Counter ....................................................................................... 482
20.6.1 Using the Pulse Counter in Limit Counter Mode.......................................................... 483
20.7 AT^SPIO GPIO Driver Open/Close........................................................................................... 484
21. Appendix .............................................................................................................................................. 485
21.1 Star-Hash (*#) Network Commands............................................................................................ 485
21.2 Available AT Commands and Dependency on SIM PIN ............................................................. 488
21.3 Availability of AT Commands Depending on Operating Mode of ME.......................................... 494
21.4 AT Command Settings storable with AT&W................................................................................ 500
21.5 Factory Default Settings Restorable with AT&F.......................................................................... 502
21.6 Summary of Unsolicited Result Codes (URC)............................................................................. 504
21.7 Alphabetical List of AT Commands ............................................................................................. 508