Intermec Antares 2420 - Page 128

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
3-26
Bar Code Symbologies Table (continued)
Parameter (Syntax) Options Location in Configuration Menu
UPC/EAN (continued)
• Check digit
Discard
Retain
• Number system digit
Discard
Retain
• UPC-A leading zero
Discard
Retain
RF Network Communications Table (T2425 Only)
Note:
The RF network parameters are different for each type of RF network protocol, TCP/IP or UDP Plus,
loaded on the terminal.
Parameter (Syntax) Options Location in Configuration Menu
Acknowledgement Delay Lower
Limit (NV)
300 milliseconds
200 - 2000 milliseconds
Communications Menu,
Advanced Network option
Acknowledgement Delay Upper
Limit (NU)
5000 milliseconds
2000 - 60000 milliseconds
Communications Menu,
Advanced Network option
Controller Connect Check
Receive Timer (NP)
60 seconds
1 - 3600 seconds
Communications Menu,
Advanced Network option
Controller Connect Check Send
Timer (NQ)
35 seconds
1 - 3600 seconds
Communications Menu,
Advanced Network option
Controller IP Address (NC)
0.0.0.0
The IP address field is four
numbers separated by periods.
Communications Menu,
Primary Network option
Default Router (NX)
0.0.0.0 (no default router)
The Router field is four numbers
separated by periods.
Communications Menu,
Advanced Network option
Host IP Address (NC)
0.0.0.0
The IP address field is four
numbers separated by periods.
Communications Menu,
Primary Network option
Maximum Retries (NR)
7
0 – 99
Communications Menu,
Advanced Network option
Network Activate (NA)
Disabled
2.4 GHz RF
Communications Menu,
Primary Network option