Error Messages C
Keysight Models 6811C, 6812C, and 6813C Programming Guide 303
–131 Invalid suffix [unrecognized units, or units not appropriate]
–138 Suffix not allowed
–141 Invalid character data [bad character, or unrecognized]
–144 Character data too long
–148 Character data not allowed
–150 String data error
–151 Invalid string data [e.g., END received before close quote]
–158 String data not allowed
–160 Block data error
–161 Invalid block data [e.g., END received before length satisfied]
–168 Block data not allowed
–170 Expression error
–171 Invalid expression
–178 Expression data not allowed
Execution errors –200 through –299 (sets Standard Event Status Register bit #4)
–200 Execution error [generic]
–221 Settings conflict [check current device state]
–222 Data out of range [e.g., too large for this device]
–223 Too much data [out of memory; block, string, or expression too long]
–224 Illegal parameter value [device-specific]
–225 Out of memory
–270 Macro error
–272 Macro execution error
–273 Illegal macro label
–276 Macro recursion error
–277 Macro redefinition not allowed
Table C-1 Error numbers (continued)
Error # Error string [description/explanation/examples]
To Next Page
Loading...
Need help?
General
