Commissioning
5-18
L
EDSVS9332P-C EN 3.0
Description of the input template
<End Sub>Click on the ”Programming” buttoninthe”Basic settings” dialog box.
12345
6
7
8
Fig. 5-13 Dialog box for entering the positioning data
Field
Function Description
1 Dialog box for a program set
(PS)
All necessary positioning profile parameters for a PS are entered as well as possible branches to
further PS.
2, 3 Parameter field Click on the field. A dialog box (3) for selecting a parameter is opened.
4, 5, 6 Selection field Here, the parameter is selected. Click on the desired parameter. For variable tables (VT) you can
describe the table positions. For this, click on ”Input” (5). A dialog box (6) opens for entering a
parameter.
6 Dialog box Dialog box for entering a parameter in the variable table.
7 I nput field Input of the desired parameter.
8 Comment on the parameter You can write a comment on the parameter, e.g. for which function it is required.
To Next Page
Loading...
