Lenze 9300 - Page 490

Configuration
7-359
L
EDSVS9332P-D22 EN 3.0
Code ImportantPossible settings
No. SelectionLenzeLCD
C1135
0
1 (C1130/1)
2 (C1130/2)
C1136 (C1131 0
C1137 (C1132) 0 -2147483647 {1} 2147483647
[C1160] → Selection list 1
ASW3
1 IN1 1000 FIXED0%
Configuration - analog input signals
2 IN2 1000 FIXED0%
[C1161] SET 1000 FIXED0 → Selection list 2 ASW3
Configuration - digital input signal
C1162
0
-199.99 {0.01 %} 199.99
1 (C1160/1)
2 (C1160/2)
C1163 (C1161) 0
[C1165] → Selection list 1
ASW4
1 IN1 1000 FIXED0%
Configuration - analog input signals
2 IN2 1000 FIXED0%
[C1166] SET 1000 FIXED0 → Selection list 2 ASW4
Configuration - digital input signal
C1167
0
-199.99 {0.01 %} 199.99
1 (C1165/1)
2 (C1165/2)
C1168 (C1166) 0
C1180 IDENT MODE 0
0 inactive
Identification mode of control parameters
1 Calculate control parameters from data set
o
o
o
o
o
p
2 Identify only parameters
3 Calculate only parameters for control system and
control
C1181 ID STATE 0
Status: controller ident.
0 inactive inactive
1 busy busy
2 Error: no calculation Error
3 Error: no identification
4 Error: C0057 small
4 Error: n <> 0
6 Error: RSP
7 Error: C1185 big
8 Error: overtime
9 Error: bad condi tion
10 wait for start Waiting for enable to start the movement
11 motion Waiting for end of movement
12 wait for RSP Waiting for controller inhibit for completion
99 Error: internal Internal error
C1182 PHI-ID PHASE 100 0.5 {0.1 rev} 3000 phi max controller ident.
C1183 N-ID MAX 100 10 {1 %} 100 n max controller ident.
C1184 M-ID MAX 100 10 {1 %} 100 m max controller ident.
C1185 M RISETIME 100 10 {1 ms} 10000 M acceleration time
C1186 OPTIMISE ID 0 0
1
Optimum control
Fault
Optimisation: controller ident.
C1187 INERTIA 0 0 {0.1 kg*cm
2
} 214000 Inertia
C1188 FRICTION 0 0 {1 %} 100 Friction load component (n-prop.)
Show/Hide Bookmarks