Configuration
7-358
L
EDSVS9332P-D22 EN 3.0
Code ImportantPossible settings
No. SelectionLenzeLCD
[C1111] → Selection list 1
FCNT3
1 LD-VAL 1000 FIXED0%
Configuration - analog input signals
2 CMP-VAL 1000 FIXED0%
[C1112] → Selection list 2
FCNT3
1 CLKUP 1000 FIXED0
Configuration - digital input signals
2 CLKDWN 1000 FIXED0
3 LOAD 1000 FIXED0
C1113
0
-32768 {1} 32768
1 (C1111/1)
2 (C1111/2)
C1114
0
1 (C1112/1)
2 (C1112/2)
3 (C1112/3)
C1120 SYNC MODE 2 0
1
2
off
CAN sync
Terminal sync
SYNC1
Function selection
[C1121] 0 {1 ms} 13 SYNC1
1 SYNC CYCLE 2 Definition of the cycle time of the sync signals
(in the slave)
•
for system bus only
2 INTERPOL. CYCL 2 Definition of the interpolation time between the
sync signals (in the slave)
•
only for terminal
•
the i nterpolation is restarted with every sync
signal
C1122 SYNC TIME 0.460 0.000 {0.001 ms} 10.000 SYNC1
Phase shift between CAN sync and internal
control program cycle
•
for system bus only
•
depending on the baud rate and bus load
C1123 -0.450 {0.001 ms} 0.450 SYNC1
1 PHASE SHIFT 0.000 Phase shift between terminal sync and internal
control program cycle
•
only for terminal sync
2 SYNC WINDOW 0.200 Synchronisation window for the synchronisation
edge of the terminal sync (LOW/HIGH edge)
•
only for terminal sync
•
if the sent sync signal is in the window,
SYNCx-STAT = HIGH
[C1124] IN1 1000 FIXED0% → Selection list 1 SYNC1
Configuration - analog input signal
[C1125] IN2 1000 FIXED0INC → Selection list 3 SYNC1
Input signal configuration
[C1126] IN3 1000 FIXED0% → Selection list 1 SYNC1
Configuration - analog input signal
C1127 (C1124)
0
-2147483647 {1} 2147483647
C1128 (C1125)
0
-2147483647 {1} 2147483647
C1129 (C1126)
0
-2147483647 {1} 2147483647
[C1130] → Selection list 1
CONVPHPH2
1 NUM 1000 FIXED0%
Configuration - analog input signals
2 DEN 1000 FIXED0%
[C1131] ACT 1000 FIXED0 → Selection list 2 CONVPHPH2
Configuration - digital input signal
[C1132] IN2 1000 FIXED0INC → Selection list 3 CONVPHPH2
Input signal configuration
To Next Page
Loading...
