How to fix undervoltage on Lenze Controller?
If your Lenze Controller displays an 'Undervoltage' error, it means the DC bus voltage is lower than the value fixed under C0173. Check the mains voltage and the supply cable.
What to do if Lenze 9300 exceeds maximum speed?
If your Lenze Controller indicates 'Max. speed exceeded (C0596),' it suggests that the active load is too high or the drive is not speed-controlled with excessive torque limitation. Check the drive dimensioning and increase the torque limit if necessary.
What to do if negative limit switch was reached on Lenze 9300?
If your Lenze Controller indicates 'Negative limit switch was reached', control the drive in the positive direction and check the terminal connection X5/E2.
What to do if positive limit switch was reached on Lenze 9300 Controller?
If your Lenze Controller indicates 'Positive limit switch was reached', control the drive in the negative direction and check the terminal connection X5/E1.
How to resolve 'No reference' error on Lenze 9300 Controller?
If your Lenze Controller shows a 'No reference' error, it means the homing point is unknown or no homing was performed before the first positioning for absolute positioning. Perform manual homing, start homing in the program, or set a reference and restart.
What to do if Lenze Controller displays initializing error?
General| Brand | Lenze |
|---|---|
| Model | 9300 |
| Category | Controller |
| Language | English |
To Next Page
