Chapter 7: Diagnostics and Maintenance
MP65492–1 149 Linx 4900 Operating Manual
5. Using the brush supplied with the printer, gently remove any ink
deposits that will not wash off from the circled area in Figure 7-15,
paying particular attention to the deflector plates (see Figure 7-16
below). Do not use the brush to clean the nozzle:
Figure 7-16 Cleaning the Printhead with the Brush
(Pigmented Inks Only)
Ensure that the cleaning brush used is the non-abrasive, solvent
resistant brush supplied with the printer.
6. Let the printhead stand for a few minutes to allow it to dry completely.
You must take particular care to ensure that the space between the
nozzle and charge electrode is free of solvent.
7. Wash the inside of the printhead cover tube with solvent until all ink
has been removed. Use the brush, where possible, to remove ink
deposits that do not immediately wash off. Finish the cleaning with a
wash and allow the cover tube to dry.
8. Refit the printhead in the cover tube and firmly tighten the securing
screw.
49297
ULTIMA
-PLUS
CLEAN ONLY THIS
AREA WITH THE BRUSH.
DO NOT USE THE BRUSH
ON THE NOZZLE
4900 Op Manual.book Page 149 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
Need help?
General
