LMI Technologies Gocator 2300 Series - Introduction

Gocator 2300 & 2880 Series
10
Introduction
The Gocator 2300 series of laser profiling sensors is designed for 3D measurement and control
applications. Gocator sensors are configured using a web browser and can be connected to a variety of
input and output devices.
This documentation describes how to connect, configure, and use a Gocator. It also contains reference
information on the device's protocols and job files.
B series Gocator sensors are only supported by firmware version 4.3 or later.
Notational Conventions
This guide uses the following notational conventions:
Follow these safety guidelines to avoid potential injury or property damage.
Consider this information in order to make best use of the product.