Gocator 2300 & 2880 Series
Gocator Device Files • Job Files • 292
Part Models
Part models represent models created using the part matching feature.
You can access a model in the active job using path notation. For example, to access a model called
scan.mdl, use "_live.job/scan.mdl".
You can access part models in user-created job files in non-volatile storage, for example,
"productionRun01.job/model1.mdl". You can only access part models in user-created job files using path
notation.
See the following sections for the elements contained in a model.
Part models contain the following subcomponents. You can access the subcomponents using path
notation, for example,"productionRun01.job/myModel.mdl/config.xml".
Element Type Description
Configuration config.xml Model configuration XML. It is always present. (See
Configuration on the
next page
.)
Edge Points edge-height-
top
Edge points for the top heightmap. (See
Edge Points below
.)
Edge Points edge-height-
bottom
Edge points for the bottom heightmap.
Edge Points edge-
intensity-top
Edge points for the top intensity map.
Edge Points edge-
intensity-
bottom
Edge points for the bottom intensity map.
Part Model Child Elements
The edge points file exists only when the model contains the source data for the edge points.
Edge Points
Field Type Offset Description
id 16s 0
Sender ID
-1 – Part matching
source 8s 2
Source
0 – Model
1 – Target
imageType 8s 3
Image type
0 – Height map
1 – Intensity map
imageSource 8s 4
Image source
0 – Top
Edge Points Data
To Next Page
Loading...
Need help?
General
