Gocator 2300 & 2880 Series
Gocator Web Interface • Measurement • 194
Plane
The Plane tool provides measurements that report angle X, angle Y, and offset Z of the surface with
respect to the alignment target. The measurement value can be compared with minimum and maximum
constraints to yield a decision.
See Adding and Removing Tools on page 134 for instructions on how to add measurement tools.
The Z offset reported is the Z position at zero position on the X axis and the Y axis.
The results of the Plane Angle X and Plane Angle Y measurements can be used to customize the tilt angle
in the Hole, Opening, and Stud tools.
2DView
3DView
To Next Page
Loading...
Need help?
General
