Gocator 2300 & 2880 Series
Gocator Web Interface • Scan Setup and Alignment • 108
Data Viewer Controls
The data viewer is controlled by mouse clicks and by the buttons on the display toolbar. The mouse
wheel can also be used for zooming in and out.
Press 'F' when the cursor is in the data viewer to switch to full screen.
Video Mode
In Video scan mode, the data viewer displays a camera image. In a dual-sensor system, camera images
from the Main or the Buddy sensor can be displayed.
Exposure View
Exposure can be set to Single, Dynamic, or Multiple. Different exposures can be displayed in the data
viewer if more than one exposure has been set. For details on setting exposure in the Exposure tab in
the Sensor panel, see on page 84.
If the Multiple option is selected in the Exposure tab and multiple exposures have been set, a drop-
down is displayed at the top of the data viewer. This drop-down lists the exposures that have been
added. Choosing an exposure changes the view of the data viewer to that exposure.
If the Single or Dynamic option is selected in the Exposure tab, the exposure drop-down will not be
shown and only one exposure will be displayed.
To Next Page
Loading...
Need help?
General
