Gocator 2300 & 2880 Series
Gocator Web Interface • Measurement • 203
See Script Measurement below for more information on the script syntax.
To create or edit a Script measurement:
1. Add a new Script tool or select an existing Script measurement.
2. Edit the script code.
3. Add script outputs using the Add button.
For each script output that is added, an index will be added to the Output drop-down and a unique ID
will be generated.
To remove a script output, click on the button next to it.
4. Click the Save button to save the script code.
If there is a mistake in the script syntax, the result will be shown as a "Invalid" with a red border in the
data viewer when you run the sensor.
Outputs from multiple measurement tools can be used as inputs to the script. A typical script would
take results from other measurement tools using the value and decision function, and output the result
using the output function. Stamp information, such as time and encoder stamps, are available in the
script, whereas the actual 3D point cloud data is not. (The script engine is not powerful enough to
process the data itself.) Only one script can be created.
Script Measurement
A Script measurement can be used to program a custom measurement using a simplified C-based
syntax. Similar to other measurement tools, a script measurement can produce multiple measurement
values and decisions for the output.
Scripts must be less than 27000 characters long.
The following elements of the C language are supported:
To Next Page
Loading...
Need help?
General
