LMI Technologies Gocator 2300 Series User Manual

Gocator 2300 & 2880 Series
Protocols • Gocator Protocol • 297
Field Type Offset Description
length 64u 0 Reply length.
type 64s 8 Reply type (0x1001).
status 64s 16 Operation status.
signature 64u 24 Message signature (0x0000504455494D4C)
deviceId 64u 32 Serial number.
dhcpEnabled 64u 40 0 – Disabled 1 – Enabled
reserved[4] byte 48 Reserved.
address[4] byte 52 The IP address in left to right order.
reserved[4] byte 56 Reserved.
subnetMask[4] byte 60 The subnet mask in left to right order.
reserved[4] byte 64 Reserved.
gateway[4] byte 68 The gateway address in left to right order.
reserved[4] byte 72 Reserved.
reserved[4] byte 76 Reserved.
Reply
Set Address
The Set Address command modifies the network configuration of a Gocator sensor. On receiving the
command, the Gocator will perform a reset. You should wait 30 seconds before re-connecting to the
Gocator.
Field Type Offset Description
length 64u 0 Command length.
type 64s 8 Command type (0x2).
signature 64u 16 Message signature (0x0000504455494D4C)
deviceId 64u 24 Serial number of the device whose address information is
queried. 0 selects all devices.
dhcpEnabled 64u 32 0 – Disabled 1 – Enabled
reserved[4] byte 40 Reserved.
address[4] byte 44 The IP address in left to right order.
reserved[4] byte 48 Reserved.
subnetMask[4] byte 52 The subnet mask in left to right order.
reserved[4] byte 56 Reserved.
gateway[4] byte 60 The gateway address in left to right order.
reserved[4] byte 64 Reserved.
reserved[4] byte 68 Reserved.
Command

LMI Technologies Gocator 2300 Series Specifications

General

Brand	LMI Technologies
Model	Gocator 2300 Series
Category	Accessories
Language	English