Gocator 2300 & 2880 Series
Gocator Web Interface • Dashboard • 221
Name Description
CPU Usage Sensor CPU utilization (%).
Encoder Value Current encoder value (ticks).
Encoder Frequency Current encoder frequency (Hz).
Memory Usage Sensor memory utilization (MB used / MB total available).
Storage Usage Sensor flash storage utilization (MB used / MB total available).
Temperature Sensor internal temperature (C).
Ethernet Traffic Network output utilization (MB/sec).
Internal Temperature Internal sensor temperature.
Processing Latency Last delay from camera exposure to when results can be scheduled to.
Processing Latency Peak Peak latency delay from camera exposure to when results can be scheduled to Rich
I/O. Reset on start.
Name Description
Scan Count Number of scans performed since sensor state last changed to Running.
Trigger Drop Count of camera frames dropped due to excessive trigger speed.
Analog Output Drop Count of analog output drops because last output has not been completed.
Digital Output Drop Count of digital output drops because last output has not been completed.
Serial Output Drop Count of serial output drops because last output has not been completed.
Processing Drop Count of frame drops due to excessive CPU utilization.
Ethernet Drop Count of frame drops due to slow Ethernet link.
Digital Output High Count Count of high states on digital outputs.
Digital Output Low Count Count of low states on digital outputs.
Range Valid Count
Count of valid ranges.
Range Invalid Count
Count of invalid ranges.
Anchor Invalid Count Count of invalid anchors.
Valid Spot Count Count of valid spots detected in the last frame.
Max Spot Count
Maximum number of spots detected since sensor was started.
Camera Search Count Count of camera frame where laser has lost tracked. Only applicable when tracking
window is enabled.
Dashboard History Values
Measurements
Measurement statistics are displayed for each measurement that has been configured on the Measure
page. Use the Reset button to reset the statistics.
The following information is available for each measurement:
To Next Page
Loading...
Need help?
General
