Gocator 2300 & 2880 Series
Protocols • Gocator Protocol • 329
Get Upgrade Status
The Get Upgrade Status command determines the progress of a firmware upgrade.
Field Type Offset Description
length 32u 0 Command size including this field, in bytes.
id 16u 4 Command identifier (0x1)
Command
Field Type Offset Description
length 32u 0 Reply size including this field, in bytes.
id 16u 4 Reply identifier (0x1).
status 32s 6
Reply status. For a list of status codes, see Commands on page
295.
state 32s 10 Upgrade state:
-1 – Failed
0 – Completed
1 – Running
2 – Completed, but should run again
progress 32u 14
Upgrade progress (valid when in the Running state)
Reply
Get Upgrade Log
The Get Upgrade Log command can retrieve an upgrade log in the event of upgrade problems.
Field Type Offset Description
length 32u 0 Command size including this field, in bytes.
id 16u 4 Command identifier (0x2)
Command
Field Type Offset Description
length 32u 0 Reply size including this field, in bytes.
id 16u 4 Reply identifier (0x2).
status 32s 6
Reply status. For a list of status codes, see Commands on page
295.
length 32u 10 Length of the log (bytes).
log[length] char 14 Log content.
Reply
Results
The following sections describe the results (data and health)that Gocator sends.
To Next Page
Loading...
Need help?
General
