Gocator 2300 & 2880 Series
Gocator Web Interface • Measurement • 146
Point Type Examples
Any Edge
Finds a rising or falling edge in the region of interest.
Median
Determines the median location of points in the region of
interest.
Fit Lines
Some measurements involve estimating lines in order to measure angles or intersection points. A fit line
can be calculated using data from either one or two fit areas.
A line can be defined using one or two areas. Two areas can be used to bypass discontinuity in a line
segment.
Measurement Tools
Area
The Area tool determines the cross-sectional area within a region. The measurement value can be
compared with minimum and maximum constraints to yield a decision.
See Adding and Removing Tools on page 134 for instructions on how to add measurement tools.
To Next Page
Loading...
Need help?
General
