Gocator 2300 & 2880 Series
• 37
The Snapshot button is used to trigger the capture of a
single profile.
Standalone
Master 400/800/1200/2400
9. Move a target into the laser plane.
If a target object is within the sensor's measurement
range, the data viewer will display the shape of the
target, and the sensor's range indicator will illuminate.
If you cannot see the laser, or if a profile is not displayed
in the Data Viewer, see Troubleshooting on page 382.
10. Press the Stop button.
The laser should turn off.
Running a Dual-Sensor System
All sensors are shipped with a default IP address of 192.168.1.10. Ethernet networks require a unique IP
address for each device, so you must set up a unique address for each sensor.
To configure a dual-sensor system:
1. Turn off the sensors and unplug the Ethernet network
connection of the Main sensor.
All sensors are shipped with a default IP address of
192.168.1.10. Ethernet networks require a unique IP
address for each device. Skip step 1 to 3 if the Buddy
sensor's IP address is already set up with an unique
address.
To Next Page
Loading...
Need help?
General
