Gocator 2300 & 2880 Series
Gocator Web Interface • System Management and Maintenance • 67
The Administrator and Technician accounts can be assigned unique passwords. By default, passwords
are blank (empty).
To set or change the password for the Administrator account:
1. Go to the Manage page and click on the Security category.
2. In the Administrator section, enter the Administrator account password and password confirmation.
3. Click Change Password.
The new password will be required the next time that an administrator logs in to the sensor.
To set or change the password for the Technician account:
1. Go to the Manage page and click on the Security category.
2. In the Technician section, enter the Technician account password and password confirmation.
3. Click Change Password.
The new password will be required the next time that a technician logs in to the sensor.
If the administrator or technician password is misplaced, the sensor can be recovered using a special
software tool. See Sensor Recovery Tool on page 373 for more information.
Maintenance
The Maintenance category in the Manage page is used to do the following:
l
upgrade the firmware and check for firmware updates;
l
back up and restore all saved jobs and recorded data;
l
restore the sensor to factory defaults;
l
reset the sensor.
To Next Page
Loading...
Need help?
General
