Gocator 2300 & 2880 Series
Gocator Device Files • Job Files • 285
In the Ethernet element, the source identifiers used for video, range, profile, and surface output, as well
as range, profile, and surface intensity outputs, correspond to the sensor that provides the data. For
example, in the XMLbelow, the options attribute of the Profiles element shows that only two sources are
available (see the table below for the meanings of these values). The value in this element—0—indicates
that only data from that source will be sent to output.
<Output>
<Ethernet>
...
<Ranges options=""/>
<Profiles options="0,1">0</Profiles>
<Surfaces options=""/>
...
Element Type Description
Protocol 32s
Ethernet protocol:
0 – Gocator
1 – Modbus
2 – EtherNet/IP
3 – ASCII
TimeoutEnabled Boolean Enable or disable auto-disconnection timeout. Applies only to the
Gocator protocol.
Timeout 64f Disconnection timeout (seconds).
Ascii Section
See Ascii on the next page.
EIP Section
See EIP on page 287.
Modbus Section
See Modbus on page 287.
Videos 32s (CSV)
Selected video sources:
0 – Top
1 – Bottom
2 – Top left
3 – Top right
Videos.options 32s (CSV) List of available video sources (see above).
Ranges 32s (CSV)
Selected range sources:
0 – Top
1 – Bottom
2 – Top left
3 – Top right
Ranges.options 32s (CSV) List of available range sources (see above).
Profiles 32s (CSV)
Selected profile sources:
Ethernet Child Elements
To Next Page
Loading...
Need help?
General
