Gocator 2300 & 2880 Series
7
Get Loaded Job 308
Get Alignment Reference 308
Set Alignment Reference 309
Clear Alignment 309
Get Timestamp 310
Get Encoder 310
Reset Encoder 310
Start 311
Scheduled Start 311
Stop 312
Get Auto Start Enabled 312
Set Auto Start Enabled 312
Start Alignment 313
Start Exposure Auto-set 313
Software Trigger 314
Schedule Digital Output 314
Schedule Analog Output 315
Ping 315
Reset 316
Backup 316
Restore 317
Restore Factory 317
Get Recording Enabled 318
Set Recording Enabled 318
Clear Replay Data 318
Get Playback Source 319
Set Playback Source 319
Simulate 320
Seek Playback 320
Step Playback 321
Playback Position 321
Clear Measurement Stats 321
Clear Log 322
Simulate Unaligned 322
Acquire 322
Acquire Unaligned 323
Create Model 323
Detect Edges 324
Add Tool 324
Add Measurement 324
Read File (Progressive) 325
Export CSV (Progressive) 326
Export Bitmap (Progressive) 327
Upgrade Commands 327
Start Upgrade 328
Start Upgrade Extended 328
Get Upgrade Status 329
Get Upgrade Log 329
Results 329
Data Results 330
Stamp 330
Video 331
Profile 332
Resampled Profile 333
Profile Intensity 333
Surface 334
Surface Intensity 334
Measurement 335
Alignment Result 336
Exposure Calibration Result 336
Edge Match Result 337
Bounding Box Match Result 337
Ellipse Match Result 337
Health Results 338
Modbus Protocol 342
Concepts 342
Messages 342
Registers 343
Control Registers 344
Output Registers 345
State 345
Stamp 345
Measurement Registers 346
EtherNet/IP Protocol 348
Concepts 348
Basic Object 349
Identity Object (Class 0x01) 349
TCP/IP Object (Class 0xF5) 349
Ethernet Link Object (Class 0xF6) 349
Assembly Object (Class 0x04) 350
Command Assembly 350
Sensor State Assembly 351
Sample State Assembly 352
ASCIIProtocol 354
To Next Page
Loading...
Need help?
General
