Driving
5.4 Off-road driving
5 - 54 3 302 633 en Operating Instructions GMK5250L
27.09.2017
Changing the
vehicle level
You can extend or retract the pre-selected suspension struts to change the
vehicle level.
Raise the level
• Press the button (1).
The pre-selected suspension struts extend.
Lower the level
• Press the button (2).
The pre-selected suspension struts retract.
The level is continuously changed until you release the button or the end
position is reached.
• Press the button (3) to confirm the selection.
During the entire procedure, the symbol for the current state is shown, e.g.
after the truck crane is inclined, the symbol (1) –
No on-road level is shown.
Viewing the
current inclination
The inclination indicator shows the current alignment.
Switching over the measuring range
The measuring range is automatically switched between 1° and 5°.
G
Risk of accidents by exceeding total permissible height!
Always bring the truck crane to on-road level before driving on roads after
changing the level.
If the truck crane is on a higher level, then the specified overall height will
be exceeded.
To Next Page
Loading...
