Malfunctions during crane operation
14.3 Warning and error messages
14 - 10 3 302 633 en Operating Instructions GMK5250L
27.09.2017
– Lattice extension angle too small
Raise the main boom;
à Operating Instructions Lattice Extension.
– Lattice extension angle too large
Lower the main boom;
– Boom angle not measured (different sensor values)
– Main boom, load capacity chart not present
– Lattice extension, load capacity chart not present
– RCL override (switch 1) not actuated
– RCL override (switch 1) actuated
– RCL override (switch 2) not actuated
– RCL override (switch 2) actuated
To Next Page
Loading...
