D-36
FX Series PLC User's Manual - Data Communication Edition
Computer Link
5 Communication Setting in FX Programmable Controller
5.3 Communication Settings Using Parameter Method (FXGP/WIN)
2. When there are already parameter settings
The existing communication setting contents are displayed.
2 Adjusting serial setting (parameter)
Execute the communication setting as shown below.
Adjust the settings on the personal computer to match those set here.
3 Writing a sequence program (parameters) to the PLC
Select [PLC] - [Transfers] - [Write] from the toolbar, and click [OK].
To Next Page
Loading...
Need help?
General
