I-23
FX Series PLC User's Manual - Data Communication Edition
Remote Maintenance
5 How to Setup Modems on the PLC Side
5.1 Setting Using GX Developer
A
Common Items
B
N:N Network
C
Parallel Link
D
Computer Link
E
Inverter
Communication
F
Non-Protocol
Communication
(RS/RS2 Instruction)
G
Non-Protocol
Communication
(FX
2N
-232IF)
H
Programming
Communication
I
Remote
Maintenance
Apx.
Discontinued
models
5.1.3 Setting AT command for unregistered modem
Only when "MODEM initialized" is set to "User register mode," "User mode [8bits NP][CH1]," or "User mode
[8bits NP][CH2]," execute the following setting.
(The modem initialization setting depends on the setting contents of the [
PLC system(1)] tab displayed
when
[Parameter] - [PLC parameter] is selected in the project tree.)
1 Newly adding a device memory
Select "Device memory" in the project tree, right-click it to display the submenu, and select
"New...".
Click the [OK] button on the "New" dialog box.
2 Creating the MAIN data
Click the [Yes] button.
To Next Page
Loading...
Need help?
General
