Mitsubishi FX3U-232-BD - 3.3.2 Correspondence between parameter setting and each communication type

A-52
FX Series PLC User's Manual - Data Communication Edition
Common Items
3 Outline of Communication Setting in the FX Series
3.3 Communication Setting in Parameter Method (FXGP/WIN)
3.3.2 Correspondence between parameter setting and each communication type
The table below shows the communication types and items which can be set using parameters:
Set item Contents
CC-Link network N:N Network Parallel link Computer link Inverter communication Non-protocol communication (RS instruction) Non-protocol communication (FX2N-232IF) Short mail sending Internet mail sending CC-Link/LT network AS-i system Programming communication Remote maintenance
Remarks
Protocol
Non-protocol
communication
This communication is not executed in this setting. This communication is not executed in this setting. This communication is not executed in this setting.
— 
This communication is not executed in this setting. This communication is not executed in this setting.

This communication is not executed in this setting. This communication is not executed in this setting. This communication is not executed in this setting. This communication is not executed in this setting.
Dedicated protocol  —— —
Data length
7-bit  —
8-bit  
Parity
None  
Odd  —
Even  —
Stop bit
1-bit  
2-bit  —
Baud rate (bps)
19200  —
9600  
4800  —
2400  —  —
1200  —  —
600  —  —
300  —  —
Header Invalid/valid — —  —
Terminator Invalid/valid — — 
Control cable Invalid/valid — —  —
Hardware type
Regular/RS-232C  — 
RS-485  —
Control mode Invalid — — — — Not selectable
Sum check Invalid/valid  —— —
Transmission control
procedure
Format 1  —— —
Format 4  —— —
Station number settings 00 to 0F  —— —
Time-out time setting 1 to 255  —  —
Reference page — B C D E F G — — — — H I