Mitsubishi FX3U-232-BD - 6. How to Setup Modems on the Personal Computer Side for Remote Access; 6.1 Setting Using GX Developer; 6.1.1 Registering AT command for connected modem

I-31
FX Series PLC User's Manual - Data Communication Edition
Remote Maintenance
6 How to Setup Modems on the Personal Computer Side for Remote Access
6.1 Setting Using GX Developer
A
Common Items
B
N:N Network
C
Parallel Link
D
Computer Link
E
Inverter Communication
F
Non-Protocol Communication (RS/RS2 Instruction)
G
Non-Protocol Communication (FX
2N
-232IF)
H
Programming Communication
I
Remote Maintenance
Apx.
Discontinued models
6. How to Setup Modems on the Personal Computer Side
for Remote Access
This chapter explains how to set a modem connected to the personal computer for remote access.
The setting method using GX Developer and the setting method using FXGP/WIN are explained respectively.
→ For applicable programming tools, refer to Subsection 1.4.2.
6.1 Setting Using GX Developer
This section explains the line connection setting method using GX Developer.
6.1.1 Registering AT command for connected modem
This subsection explains how to register the AT command for initializing a modem connected to the personal
computer.
1 Setting the AT command
Select [Tools] - [Set TEL data] - [AT command registration] from the toolbar to display the following
dialog box.
Line
general telephone
line, etc.
This chapter explains the setting procedure
for this side.
The setting procedure for this side is
explained in Chapter 5.
Remote access side
Personal computer
Cable
Modem
PLC
Modem
Cable
PLC side