Mitsubishi FX3U-232-BD User Manual

A-35
FX Series PLC User's Manual - Data Communication Edition
Common Items
2 Communication Types and Communication Equipment
2.3 Combination of Communication Equipment (Block Diagram)
A
Common Items
B
N:N Network
C
Parallel Link
D
Computer Link
E
Inverter Communication
F
Non-Protocol Communication (RS/RS2 Instruction)
G
Non-Protocol Communication (FX
2N
-232IF)
H
Programming Communication
I
Remote Maintenance
Apx.
Discontinued models
*1. The FX2N-16CCL-M and FX2N-32ASI-M cannot be used at the same time.
Limitation in the number of connectable units
Connected special function units/blocks operate using the 24V DC or 5V DC power supply of the PLC.
Accordingly, the number of connectable units depends on the system configuration.
→ For details, refer to the respective FX PLC manual.
FX 1NC Series
A
C
Up to 2 units can be selected.
CC-Link
For master
station
For remote
device station
CC-Link/LT
C
FX 2N -16CCL-M
*1
FX 2N -32CCL
C
FX 2N -64CL-M
C
FX 2N -16LNK-M
C
M3.5 terminal block
M3 terminal block
Dedicated connector
M3 terminal block
MELSEC-I/O LINK
C
FX 2NC -CNV-IF
E
R
R
O
R
CC-Link
FX 2N -16CCL-M
For special adapters with communication type , refer to the
previous page.
A
and indicate the mounting position.
A C
(For the mounting procedure, refer to the respective communication equipment manual.)



FX 2N -32ASI-M
*1
C
FX
2N
-32ASI-M
POWE
R
U
ASI
ASI
ACT IVE
PRJ
MODE
PRG
ENABLE
FROM/
TO
CONFIG
ERR
MOD
E
SE
T
ADDRESS/
ERROR
M3 terminal block
AS-i system


Mitsubishi FX3U-232-BD Specifications

General

Brand	Mitsubishi
Model	FX3U-232-BD
Category	Controller
Language	English