Mitsubishi FX3U-232-BD User Manual

A-39
FX Series PLC User's Manual - Data Communication Edition
Common Items
2 Communication Types and Communication Equipment
2.3 Combination of Communication Equipment (Block Diagram)
A
Common Items
B
N:N Network
C
Parallel Link
D
Computer Link
E
Inverter Communication
F
Non-Protocol Communication (RS/RS2 Instruction)
G
Non-Protocol Communication (FX
2N
-232IF)
H
Programming Communication
I
Remote Maintenance
Apx.
Discontinued models
*1. The FX2N-16CCL-M and FX2N-32ASI-M cannot be used at the same time.
*2. The FX
2NC-MT-D/UL and FX2NC-M-DSS(-T-DS) are not supported.
Limitation in the number of connectable units
Connected special function units/blocks operate using the 24V DC or 5V DC power supply of the PLC.
Therefore, the total current consumption larger than the plc current capacity reduces the number of
connectable units.
→ For details, refer to the respective FX PLC manual.
FX 2NC Series
A
C
D
Up to 4 units can be selected.
CC-Link
Non-protocol
communication
For master
station
For remote
device
station
CC-Link/LT
C
FX 2N -16CCL-M
*1
FX 2N -32CCL
C
FX 2N -232IF
C
POWER
SD
RD
FX 2N -64CL-M
C
FX 2N -16LNK-M
C
M3.5 terminal block
M3 terminal block
9-pin D-Sub, male
Dedicated connector
M3 terminal block
For special adapters with communication type and function
extension memory boards , refer to the previous page.
A
D
MELSEC-I/O LINK
C
FX 2NC -CNV-IF
E
R
R
O
R
CC-Link
FX 2N -16CCL-M
, and indicate the mounting position.
A C D
(For the mounting procedure, refer to the respective communication equipment manual.)




FX 2N -32ASI-M
*1*2
C
FX
2N
-32ASI-M
POWE
R
U
ASI
ASI
ACT IVE
PRJ
MODE
PRG
ENABLE
FROM/
TO
CONFIG
ERR
MOD
E
SE
T
ADDRESS/
ERROR
M3 terminal block
AS-i system


Mitsubishi FX3U-232-BD Specifications

General

Brand	Mitsubishi
Model	FX3U-232-BD
Category	Controller
Language	English