¾ 5-11 ¾
Program 12
This program selects the extensions to receive the chime tones from a Doorphone Box and program
the ring type for each. Up to ten extensions can receive the chimes from both boxes.
Display Indication Input Data Initial
DOOR# CHIME# BOX#
#####12-N# XX-STD
N. Doorphone number (1 - 2)
XX. Received extension No. (01 - 10)
(Cannot input dial)
ST. Received extension number
(10 - System Max) (00: None)
D. Incoming ring type
0: No ring 1: Day ring
2: Night ring 3: Day and Night ring
* A maximum of 10 extensions can be
programmed for each doorphone.
(N = 1-2)
(XX =
01 - 10)
ST: 00
D: 0
Program 13
This program assigns the following functions for each extension.
Display Indication Input Data Initial
STN# ASSIGNMENT3
#####13-ST-ABCDE
ST. Extension number (10 - System Max)
A. Key Touch Tone
0: Enabled 1: Disabled
B. Do Not Disturb
0: Disabled
1: Trunk calls blocked
2: Trunk and ICM calls blocked
3: Trunk and ICM calls blocked or Trunk calls
blocked.
C. Alarm Audible
0: Off 1: On
D. Voice Announce Device Port
0: Disable 1: Enable
E. Terminal Connection (Only for SLT)
0: Not connected
1: Connected
(ALL)
A: 0
B: 0
C: 0
D: 0
E: 1
To Next Page
Loading...