Nitsuko 1232 - Page 235

¾ 5-38 ¾
Program 82
This program assigns Long Conversation Cutoff timers
N=1: The timing to send Warning Tone after established the line conversation.
N=2: The timing to Cutoff the line with Warning Tone.
Display Indication Input Data Initial
FORCED CUT-OFF
###8 82-N -TTT
N=1 : Conversation timer
TTT : 001-255(min.)
N=2 : Warning Tone Sending timer
TTT:001-255(sec)
TTT:
010(N=1)
030(N=2)
Program 83
This program assigns the following options for Trunk Lines on TX-Z 1232/2464 system.
Display Indication Input Data Initial
LINE ASSIGNMENT4
#####83-LN-ABCDE
TX-Z 1232/2464 Only
A. Trunk Disconnection when detected polarity
reverse
0: Disconnect 1:Not disconnect
B. Optional/Fixed Rate Table Selection
0: Optional 1:Fixed
C. --Not used--
D. --Not used--
E. --Not used--
A: 0
B: 0
C: 0
D: 0
E: 0
Program 84
This program assigns Group Hunt Calling Timer.
Display Indication Input Data Initial
HUNT# CALL TIMER
#####84#####-TTT
TTT. Group Hunt Calling Timer
000: Not call other extension
001 - 255: 1 - 255 sec.
TTT: 015