¾ 5-39 ¾
Program 85
This program assigns the extension ports connected to NVM (Nitsuko Voice Mail) on TX-Z
1232/2464.
Display Indication Input Data Initial
VOICE MAIL PORT
#####85#####NN-ST
TX-Z 1232/2464 Only
NN. 01 - 08
ST. 00: Not Connected
10 - System Max: Extension Port No.
(NN = 01 -
08)
ST: 00
Program 87
This program determines how long after seizing a Trunk line a user must wait before the line can be
placed on hold.
Display Indication Input Data Initial
HD DISABLE TIMER
#####87#####-TTT
TTT. Hold Disable Timer
000: Can hold immediately
001 - 255: 1 - 255 s
TTT: 000
Program 88
This program allows an automatic Door relay contact timer to be programmed. This will set how long
the relay timer will stay contacted once activated.
Display Indication Input Data Initial
DOOR# RELAY# TIMER
#####88#####-TTT
TTT. Time for Relay contact
000: Unlock/Lock by manual
001 - 255: 0.1 - 25.5 s
(Locked after assigned timer is over.)
TTT: 000
Program 89
This program assigns the delay required from the point of seizing a Trunk line to the point where the
system dials the digits entered by the end user. This timer should be longer than the first dial waiting
timer of CO line's specification.
Display Indication Input Data Initial
DIAL# WAIT##TIMER
#####89#####-TTT
TTT. Pre-pause timer for outside dial
000 - 255: 0 - 25.5 s
TTT: 008
To Next Page
Loading...